Inventor 2017 – Simulating Motion with iLogic

By Connor Ferguson

Inventor 2017 – Simulating a screwing movement using constraints then driving with iLogic

As promised in my previous post the below video shows how you can set up a couple of

different constraints to simulate a screwing movement. I use a custom snippet in the iLogic rule,

for more information about these click the below link.

https://www.cadlinecommunity.co.uk/hc/en-us/articles/201769622-Inventor-iLogic-Snippets

The code is attached below

• Inventor 2017 – Simulating a screwing movement using constraints then driving with iLogic.txt704 Bytes