Civil 3D 2015 - Trimming Surfaces using ‘Maximum Angle’ Check

Zen Admin
Zen Admin
  • Updated

by Graham Riddleston

How to trim the exterior boundary of a triangulated surface using the maximum angle definition option.

Introduction

Creating a triangulated surface in Civil 3D can something include extraneous information at the outside of the surface due to triangles being created over concave areas. This is often the result of inadequate survey data but can sometime occur on corridor surfaces where tight horizontal curves have been used.

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.