Cadline Community

Miles Nicholson's Blog

Miles Nicholson's RSS Feed

17 May 2013

Hotfixes for AutoCAD Electrical 2013
Autodesk have released a couple of hotfixes for AutoCAD Electrical 2013.…

17 May 2013

Hotfixes for AutoCAD Electrical 2014
There have been a number of hotfixes become available for AutoCAD Electrical 2014.…

16 April 2013

What's New in AutoCAD Electrical 2014
What's New in AutoCAD Electrical 2014…

16 April 2013

Cadline Localiser
Now that AutoCAD Electrical 2014 is available for download and includes a metric panel library, do you still need the Cadline Localiser?…

26 March 2013

Hotfix: Express Tools Ribbon commands
Autodesk have released a hotfix that addresses issues with Express Tools Ribbon commands not functioning properly in AutoCAD Electrical 2013. To install the hotfix patch, you must have…

25 March 2013

Far more than just electrical schematics
AutoCAD Electrical in theory should be called “AutoCAD Controls” or “AutoCAD Schematics” as it does far more than just electrical schematics. Single line, topology, cable block, overview, pneumatic…

01 March 2013

Are you thinking about upgrading your PC?
When upgrading your PC it is highly recommended to check whether the hardware is suitable to run AutoCAD specifically the graphics card. It is also useful to ascertain if your graphics card drivers ar…

21 February 2013

Forthcoming AutoCAD Electrical LIVE! Event
Just a reminder about the forthcoming LIVE! Event on using AutoCAD Electrical for pneumatics and hydraulics.The webcast is scheduled for the 1st march at 11am and will last for approximately an hour…

05 February 2013

AutoCAD Electrical: Reverse Engineering
Have you ever wondered how you can create a panel layout and then create a schematic from the list of parts used in the panel layout? Do you want to create either your panel layout or your…

04 February 2013

AutoCAD Electrical LIVE! - Terminals
A new video has just been added to the CADline Community which explains how to define terminals, multi-deck terminals and jumpers correctly within your schematics.…